Sony ILME-FX3 Help Manual page 451

4.
Launch Creators' App on your smartphone and open the [Cameras] screen.
5.
Select the (Setup) button in the upper right corner of the [Cameras] screen, and then select [Connect only via Wi-
Fi].
6.
Follow the instructions on the screen and open the Wi-Fi setting screen on your smartphone.
7.
On the Wi-Fi setting screen on your smartphone, select the SSID displayed on the camera and enter the password.
8.
Switch the screen back to Creators' App on your smartphone and select the product name of the camera (ILME-
FX3).
9.
Follow the instructions on your smartphone screen to select the access authentication information for the camera and
display information such as the username, password, and fingerprint.
10.
Enter and confirm the access authentication information on your smartphone.
The smartphone will connect to the camera.
About one-touch connection with NFC
Although this camera is equipped with an NFC function, you cannot connect the camera to a smartphone using the NFC
function if the camera's system software (firmware) is Ver2.0 or later.
Note
[Smartphone Connection] cannot be executed when [Airplane Mode] is set to [On].
Up to 2 devices can be connected to the camera at the same time using Bluetooth communication.
Radio wave interference may occur as Bluetooth communications and Wi-Fi (2.4 GHz) communications use the same frequency
band. If your Wi-Fi connection is unstable, it may be improved by turning off the Bluetooth function of the smartphone.
Related Topic
Functions available with a smartphone (Creators' App)
Using a smartphone as a remote commander
Select on Cam & Send (transferring to a smartphone)
Cnct. while Power OFF (smartphone)
Reading location information from a smartphone
5-043-414-12(1) Copyright 2022 Sony Corporation
451