Morso 6100 Instructions For Installation And Use Manual page 25

1.6 Connecting the flue pipe
Lift the upper cast iron top plate off the stove.
Note: The included round cast iron cover plate must be mounted on the upper cast iron top
plate if the stove is being installed with the flue pipe to the rear.
Mounting the flue collar pointing upwards
From the factory, the stove is prepared for installation with the included flue collar (1) pointing
upwards with included ball stop and screws. The ball stop, which prevents the chimney sweep
from damaging the stove's baffle plates while sweeping, is the 145 mm long rod that is provided.
Mounting the flue collar to the rear
If the stove is being installed with the
flue pipe to the rear, the round plate
fixed with two screws on the back
of the stove is dismounted. The iron
piece on the inside convection back
panel is knocked out with light, firm
taps with a hammer next to the small
"bridges" holding the piece.
The cast iron cover is removed from
the back panel and mounted on the
top plate. The flue collar is centred and
screwed onto the back of the stove
with the clamps and screws provided.
The ball stop is not used when install-
ing the flue collar to the rear.
The location of the baffles
The baffles (2) and (3), which are made
from vermiculite, are mounted at the
factory.
Make sure that the baffles are correct-
ly assembled before lighting the stove
(please see the sketch).
25