Table of Contents
Advertisement
Installing the Setting Plate
c
When multiple projectors are installed in the same room, we recommend that you set projector IDs
to prevent remote control interference.
Turn on a projector and set the ID number for the projector in Installation > Projector ID. When
you want to operate a specific projector, hold down the [ID] button on the remote control and press
the button with the same number as the projector ID.
• Adjusting using the Setting Plate Installation Guide ( p.48)
Manually adjust the position of the setting plate according to the guide screen displayed. This is useful when you
want to perform fine adjustments to the projection position while maintaining the image quality.
• Adjusting using the initial setup wizard
Adjust the projection position using the initial setup wizard that is displayed when you turn on the projector for the
first time.
• Adjusting using the projector menus ( p.52)
Select the area you want to adjust and manually correct the image. This is useful when you want to make fine
adjustments to the projection position after making mechanical adjustments using the guide screen.
Quick Corner
Arc Correction
47
Point Correction
Advertisement
Table of Contents
