Table of Contents
Advertisement
Installing the Setting Plate
c
Determine the positions for the mounting holes for the wall plate
From the screw holes shown in the figure below, secure at least four points at the top, bottom, left,
and right for optimum balance.
d
Drill the holes in the wall
Drill diameter: 10.5 mm (M10) or 10 mm (3/8 inches)
Pilot hole depth: 45 mm
Anchor hole depth: 40 mm
c
When routing cables to the projector through a wall, you can drill holes within the area shown
in the figure below and use them as cable routing holes.
e
Remove the template sheet
f
Place the wall plate on the temporary M10 screw that you installed in step 2
10.5mm (M10)
or
10mm (3/8 inch)
37
45mm
Advertisement
Table of Contents
