Advertisement
E N
N A N T E
TO WER FA N
OPERATING INSTRUCTIONS
Read the instructions carefully before operating the appliance or carrying out maintenance work. Observe
all the safety instructions; failure to do so may lead to accidents and/or damage. Store these instructions in
a safe place for future reference.
V 02/23
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Argo NANTE
Summary of Contents for Argo NANTE
- Page 1 N A N T E TO WER FA N OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance work. Observe all the safety instructions; failure to do so may lead to accidents and/or damage. Store these instructions in a safe place for future reference.
- Page 2 GENERAL OPERATING AND SAFETY INSTRUCTIONS • Use this fan only as described in this manual. Any other use not recommended by the manufacturer can cause fires, electric shocks, or personal injury. • Make sure that the type of power supply complies with the electrical demands of the fan (220-240V~50/60Hz).
- Page 3 grids with the help of a vacuum cleaner. • Do not use abrasive products to clean the appliance. Clean it with the help of a damp (not wet) cloth and let it dry completely before putting it away. Remove the plug from the socket before doing maintenance. •...
- Page 4 ATTENTION: THE ON/OFF SWITCH IS NOT THE ONLY MEANS TO DISCONNECT THE POWER SUPPLY. IN THE EVENT OF NOT USING, MOVING OR MAINTAINING THE APPLIANCE, ALWAYS UNPLUG THE PLUG FROM THE SOCKET. • Do not use the appliance on soft surfaces, such as a bed, where the grids may be covered.
-
Page 5: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE 1. Control panel 2. Rear panel 3. Front panel 4. Base INSTALLATION OF BASE Before putting the appliance into operation, it is necessary to assemble and mount the base. • Hook the front base and the rear base, fixing them with two screws (Fig.1) •... -
Page 6: Function Controls
FUNCTION CONTROLS BY REMOTE CONTROLLER How to insert the battery into the remote controller Open the battery door on the back of the remote controller by pressing the back and pulling the door. Place the battery in the door, taking care to check that the polarities are positioned correctly. Insert the door into the remote controller. Use a Lithium/Manganese button cell, model no. - Page 7 FOR OPTIMAL REMOTE CONTROLLER OPERATION, POINT THE TRANSMITTER HEAD TOWARDS THE RECEIVER LOCATED ON THE FAN. CONTROL BY REMOTE CONTROLLER 1. ON/OFF button 2. Swing button 3. Timer button 4. Mode button 5. Fan Speed button CONTROL BY CONTROL PANEL 1.
-
Page 8: Care And Maintenance
4. MODE BUTTON Press this button on the control panel or on the remote controller to select the operating mode, in the following circular sequence: Normal - Natural - Sleep On the control panel, the LEDs light up according to the selection made. 5. - Page 9 www.argoclima.com Argoclima assumes no responsibility for any errors or inaccuracies in the content of this manual and reserves the right to make to this, at any time and without notice, any changes deemed appropriate for any technical or commercial need. V 02/23...
Need help?
Do you have a question about the NANTE and is the answer not in the manual?
Questions and answers