Advertisement
EN
DESK AND STAND FAN
OPERATING INSTRUCTIONS
Read the instructions carefully before operating the appliance or carrying out maintenance operations.
Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage.
Keep these instructions in a safe place for future reference.
V 11/15
9
Advertisement
Table of Contents
Related Manuals for Argo TABLO
Summary of Contents for Argo TABLO
- Page 1 DESK AND STAND FAN OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance operations. Observe all the safety instructions; failure to observe the instructions may lead to accidents and/or damage. Keep these instructions in a safe place for future reference. V 11/15...
-
Page 2: General Safety Information
GENERAL SAFETY INFORMATION • Use this fan only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to people. • Ensure that the mains power complies with the voltage specified on the fan ’s data plate (220-240V~/50Hz). •... - Page 3 DESK FAN - DESCRIPTION OF PARTS 1. Front grille 2. Nut 3.Blade 4. Ring 5. Body 6. Control panel 7. Buttons 8. Base 9. Remote control STAND FAN - DESCRIPTION OF PARTS 1. Front grille 2. Nut 3. Blade 4. Ring 5.
- Page 4 STAND AND TABLE FAN - ASSEMBLY INSTRUCTIONS Open the box and remove the parts of the appliance. Motor shaft. Insert the rear grill on the motor shaft Set the blade on the motor shaft. in the proper position (hanlde upward). Screw the nut in order to fasten the rear grill firmly.
-
Page 5: How To Use The Appliance
STAND FAN - ASSEMBLY INSTRUCTIONS Open the box and remove the parts of the appliance. CONNECT THE ROD TO THE BASE USING THE SUPPLIED LOCKING LEVER AND FOLLOW THESE INSTRUCTIONS: 1. The fan is supplied with the locking 2. Loose the locking lever. 3. - Page 6 Press ON/OFF on the control panel or remote control. A sound will indicate that the appliance is on, with low fan speed. This fan can be used both as a fan, with 3 modes (NATURE, SLEEP and NORMAL,, when no mode has been selected) and 3 fan speed options (low, medium and high).
-
Page 7: Remote Control
REMOTE CONTROL TIMER button MODE SELECTION button (MODE) Allows you to adjust 3 modes: SLEEP, NATURE or NORMAL (no mode selcted). SPEED button SWING button (OSC) ON/OFF button HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below) Open the battery cover on the back of the remote control (press and pull the cover). - Page 8 If the fan is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower than 50°C. Let the fan dry completely before use. Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical substances or other items to clean that may damage the surface.
Need help?
Do you have a question about the TABLO and is the answer not in the manual?
Questions and answers