Husqvarna AUTOMOWER 210 C Quick Manual page 2

G ET TI NG STA RTE D W ITH
H U SQVA R N A AUTO M OW E R
1 PLAC E M E NT AN D CON N ECTION OF LOOP G E N E R ATOR /C HARG E R
AN D C HARG I NG OF BAT TE RY
See chapters 3.2 and 3.3 in the Operator's Manual.
1. The loop generator/charger must be placed where it is well
ventilated and is not exposed to direct sunlight.
2. Connect the loop generator/charger's power cord to a
mains wall socket. The 120V transformer (USA) is for
indoor use only.
3. Connect the charger cable from the loop generator/
charger to the charger contact on the mower. The green
indicator lamp Battery should now now be lit with a
steady light.
2 PL AC I NG TH E BOU N DARY WI RE
See 3.4 in the Operator's Manual
1. Run the boundary wire ensuring it
forms a loop around the work area.
30 cm / 12"
1. Catch button to open the cutting
height adjustment cover
2. STOP button
3. Charger contact
4. Connection to boundary wire
1
5. LED for performance inspection
of boundary wire
6. Indicator lamps
7. Keypad
™
2
0 cm / 0"
2
4
3
ZONE CLASSIFICATION
If the mowing results in the garden are uneven due to the
shape of the garden, for example because of a long passage,
you have the option of dividing up your garden into zones.
When the mower is placed in zone 1, it will not mow in zone
2 and vice versa. Move the mower between the zones to
maintain even mowing results.
3
3 CON N ECTI NG TH E BOU N DARY WI RE
See chapter 3.5 in the Operator's Manual
1. Open the connector and run the wire ends in the recesses
2. Press the connector together using a pair of pliers.
3. Cut off any surplus boundary wire.
10 cm / 4"
4. Attach the connector to the contact pin on the loop
35 cm / 14"
5
7
6
Loop generator/charger
on each connector.
Cut 1-2 cm / 0.5" above the connector.
generator/charger.
Boundary wire and Clinchers
coupler
30 cm
Zone 1
Zone 2
1
2
3
4
Connector Measurement gauge