LAVAZZA Firma INOVY MINI Instructions Manual page 36

EN
N° Problem encountered
Water leaks at the front side of
5
the coffee machine.
Water leaks at the rear side of
6
the coffee machine.
The loading lever does not
reach the supply position or
7
requires an excessive closing
effort.
Blinking red warning light
8
ON .
Pilot lights ON with white
9
light and blinking fast.
Coffee is dispensed too fast
10 and, therefore, it is not so
creamy.
36
TROUBLESHOOTING
Possible causes
1 - Spent capsule drawer not
inserted correctly.
2 - Spent capsule drawer
filled.
3 - Capsule stuck.
4 - Capsule not compatible.
1 - Tank not inserted correctly. Insert the tank correctly.
2 - Tank damaged.
1 - Spent capsule drawer
filled.
2 - Capsule fitted incorrectly.
1 - The temperature
measured inside the
machine is lower than 5°C.
1 - Spent capsule drawer
filled.
1 - Capsule not compatible.
2 - Insertion of a soluble
product pod instead of a
coffee one.
Solution
Insert the spent capsule drawer
correctly.
Empty the spent capsule drawer
and the drip tray.
Lift and lower the capsule
loading lever. If this is not
enough, disconnect the machine
from power mains and operate
manually to remove the capsule
from the duct.
Use Lavazza capsules or
compatibles.
Check for leaks in the tank
keeping it separate from the
machine.
Empty the spent capsule drawer.
Repeat the sequence, lever in
the off position, lever in the
brewing position; if this is not
enough, operate manually
to remove the capsule from
the duct with the machine
disconnected from power mains.
Disconnect the plug from the
socket, then allow the machine
to rest at ambient temperature
for the necessary time.
(N.B. Depending on the initial
temperature, this time may be of
up to 2 hours).
Connect the machine plug again
to the socket, then press either
push-button.
Empty the spent capsule drawer
and press one of the power
on/supply buttons to reset the
machine.
Use Lavazza capsules or
compatibles.
Use a Lavazza coffee pod
(or any one compatible pod).
Result
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: call solved.
Non-ok: go to step 4
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: passare al punto 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.