Commercial Boilers; Burner Equipment - Riello RLS 160/E MX Installation, Use And Maintenance Instructions

4.9

Commercial boilers

The burner is suitable for operating on both flame inversion boil-
ers (*), as well as on boilers with a combustion chamber with run-
off from the bottom (three flue passes) on which the best results
for low NO emissions are obtained.
x
The boiler front door maximum thickness must not exceed 250
mm (Fig. 4).
The coupling is ensured when the boiler is EC type-approved; for
boilers or ovens with combustion chambers of very different di-
mensions compared to those shown in the diagram of (Fig. 3)
preliminary checks are recommended.
(*) For flame inversion boilers, a kit is available to reduce the CO,
if necessary.
4.10

Burner equipment

1Flange for gas train . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Extensions for slide bars (TC version) . . . . . . . . . . . . . . . . No. 2
Extensions for slide bars (TL version) . . . . . . . . . . . . . . . . No. 4
Gasket for flange . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
M10x35 screws to fix the gas flange . . . . . . . . . . . . . . . . . No. 4
Thermal insulation screen . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Screws M16x50 to fix the burner flange to the boiler . . . . . No. 4
Flexible hoses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Fittings for hoses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Gaskets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 2
Spare parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Instruction booklet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Technical description of the burner
11 GB
250 mm MAX
D1079
Fig. 4
20121303