Table of Contents
Advertisement
Wired Controller
Connect the wired controller (RUX-CSP1) to the DSP
correctly, and ensure that it starts normally before
use.
Startup Screen
After the wired controller is started, the dynamic
startup screen appears, as shown in Figure 1.
Figure 1
Master Volume
After it is started, enter the main interface of the
wired controller-Master Volume Interface, as shown
in Figure 2-1. Turn the button to adjust the master
volume. Turning it clockwise can increase the
volume, while turning it counterclockwise will
decrease the volume. The adjustment range is from
0 to 35. In addition, pressing the master volume
interface of the wired controller briefly can mute the
DSP. The mute interface is as shown in Figure 2-2.
Figure 2-1
Figure 2-2
Subwoofer Volume (SUB W)
Press and hold the button in the main interface for
1~4 seconds to enter the subwoofer volume (SUB
W) interface, as shown in Figure 3. Turn the button
of the wired controller to adjust the subwoofer
volume. Turning it clockwise can increase the
volume, while turning it counterclockwise will
decrease the volume (Adjustment range: 0~15).
When the volume is turned to the desired volume,
press the button briefly to determine the selected
volume, and then return to the main volume
interface directly.
Note:
If the wired controller is not operated for about
4 seconds, it will exit from the interface to the main
interface (Master Volume Interface).
Figure 3
Sound Effect Presets (PRESET)
Press and hold the button in the main interface for
over 4 seconds to enter the sound effect presets
interface. And then turning the button to move the
cursor to the sound array "1~6" or enter the "Skip"
page, as shown in Figure 4-1. The number after
PRESET refers to the sound effect data currently
used by the DSP.
Figure 4-1
27-
EN
Advertisement
Table of Contents
