Removing The Solid-State Drive 2 - Dell XPS 15 9510 Service Manual

Steps
1. Align the notch on the solid-state drive 1 with the tab on the solid-state drive slot.
2. Gently slide the solid-state drive 1 into the solid-state drive slot.
3. Slide the solid-state drive thermal bracket into the alignment post on the system board, and align the screw hole on the
solid-state drive thermal bracket with the screw hole on the system board.
NOTE: The size of the solid-state drive thermal bracket varies based on the storage type. A solid-state drive thermal
bracket that is designed for an M.2 2280 drive cannot accommodate an M.2 2230 drive and vice versa.
4. Replace the screw (M2x2) that secures the solid-state drive thermal bracket and the solid-state drive 1 to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Removing the solid-state drive 2

Prerequisites
1. Follow the procedure in
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
CAUTION: To avoid data loss, do not remove the solid-state drive while the computer is turned on or is in
sleep state.
2. Remove the base cover.
About this task
The following image indicates the location of the solid-state drive 2 and provides a visual representation of the removal
procedure.
22 Removing and installing components
After working inside your
Before working inside your
computer.
computer.