Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x4) that secures the I/O board to the palm-rest and keyboard assembly.
4. Align the screw hole on the USB Type-C port bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the USB Type-C port bracket to the system board.
NOTE:
Ensure to connect IO marked side of the I/O-board cable to the I/O daughter board and the side marked MB to
the system board.
6. Connect the I/O-board cable to the connector on the system board and I/O board.
Next steps
1. Install the
right
fan.
2. Install the
base
cover.
3. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following images indicate the location of the display assembly cable and display-assembly hinges and provide a visual
representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
35