Table of Contents
Advertisement
Figure 70
1. Nut
2. Stationary plate
3. Control plate
12.
Move the motion-control levers to the R
position and while applying slight pressure to
the lever, allow the reverse-indicator springs to
bring the levers back to neutral.
Note:
The wheels should stop turning or slightly
creep in reverse.
Note:
You may need to remove the
motion-control cover to gain access.
13.
Shut off the machine.
14.
Remove the jumper wire from the wire harness
and plug the connector into the seat switch.
15.
Remove the jack stands.
16.
Raise the mower deck and install the
height-of-cut pin.
17.
Check and ensure that the machine does
not creep in neutral with the parking brake
disengaged.
g036753
4. Return-to-neutral plate
5. Tabs touching return to
neutral plate
EVERSE
Hydraulic System
Maintenance
Hydraulic System Safety
•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
Hydraulic Fluid
Specifications
Hydraulic Fluid Type: Toro
hydraulic fluid or Mobil 1 15W-50 oil.
Important:
Use the specified fluid. Other fluids
could damage the hydraulic system.
Hydraulic System Capacity (with filters removed):
4.45 L (150 fl oz)
Checking the Hydraulic
Fluid Level
Service Interval: Before each use or daily
1.
Allow the hydraulic fluid to cool down. Check the
oil level when the fluid is cold.
2.
Check expansion reservoir and if necessary
add Toro
®
HYPR-OIL
FULL COLD line.
54
®
HYPR-OIL
™
500
™
500 hydraulic fluid to the
Advertisement
Table of Contents
