Bleeding The Hydraulic System - Toro 74453TE Operator's Manual

3. Repeat for the opposite filter.
4. Install the filter guards over each filter that you
previously removed.
5. Use the 3 screws to secure the filter guards.
6. Verify that the vent plugs are removed before
adding the fluid.
7. Slowly pour the specified fluid through the
expansion reservoir until fluid comes out of 1
of the vent-plug holes.
8. Install the vent plug.
9. Torque the plug to 20 N∙m (15 ft-lb).
10. Continue to add fluid through the expansion
reservoir until fluid comes out of the remaining
vent-plug hole on the second transmission.
11. Install the opposite vent plug.
12. Torque the plug to 20 N∙m (15 ft-lb).
13. Continue to add fluid through the expansion
reservoir until it reaches the F
the expansion reservoir.
14. Proceed to

Bleeding the Hydraulic System

(page 56).
Important:
Failure to perform the Bleeding
the Hydraulic System procedure after
changing hydraulic filters and fluid can
result in irreparable damage to the transaxle
drive system.
C line on
ULL OLD
Bleeding the Hydraulic
System
56
Figure 73
1. Raise the rear of machine and support it with
jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
Figure 74
1. Jacking points
g027477
g017625