Controls System Maintenance; Adjusting The Control-Handle Position - Toro 74453TE Operator's Manual

122cm or 132cm riding mower
Table of Contents

Advertisement

Figure 66
1. Clutch stop
6.
Remove the idler spring from the post
67).
7.
Remove the existing belt from the
hydraulic-pump-drive pulleys and the
engine pulley.
8.
Install the new belt around the engine pulley and
the 2 hydraulic-pump pulleys
Figure 67
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9.
Install the clutch stop
10.
Install the mower belt; refer to
(page
50).
g036860
(Figure
(Figure
67).
g036859
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure
66).
Belt Maintenance
Controls System
Maintenance
Adjusting the
Control-Handle Position
If the ends of the levers hit against each other, refer to
Adjusting the Motion-Control Linkage (page
Adjusting the Height
You can adjust the motion control levers higher or
lower for maximum comfort.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the hardware holding the control lever
to the control-arm shaft.
1. Bolts
2. Slotted hole
4.
Move the control lever to the next set of holes.
Secure the lever with the hardware.
5.
Repeat the adjustment for the opposite control
lever.
52
53).
Figure 68
3. Control lever
4. Control-arm shaft
g035858

Advertisement

Table of Contents
loading

This manual is also suitable for:

Titan hd 1500 series74454te

Table of Contents