Servicing The Fuses - Toro TimeCutter MX 5050 Operator's Manual

1. Positive battery post
2. Negative battery post
Installing the Battery
1. Position the battery in the tray
2. Install the positive (red) battery cable to the positive (+)
battery terminal using the fasteners removed previously.
3. Install the negative battery cable to the negative (-)
battery terminal using the fasteners removed previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down
6. Lower the seat.
Figure 40
3. Red (+) charger lead
4. Black (-) charger lead
(Figure 39).
(Figure

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
•
Main F1-30 amp, blade-type
•
Charge Circuit F2-25 amp, blade-type
1. Remove the screws securing the control panel to the
machine. Retain all fasteners
2. Lift the control pane up to access the main wiring
harness and fuse block
3. To replace a fuse, pull out on the fuse to remove it
(Figure
39).
1. Main—30 amp
4. Return the control panel to its original position. Use
the screws removed previously to secure the panel to
the machine.
35
(Figure 41).
41).
1
2
Figure 41
2. Charge circuit—25 amp
G014921