Adjusting the Height of Cut
Note: The transport position is the highest height-of-cut
position or cutting height 4.5 inch [115 mm]
Height-of-cut is controlled by the lever located to the right of
the operating position
(Figure
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in
match the closest height-of-cut position.
(Figure
19).
Figure 19
Figure 20
19).
G010233
1. Anti-scalp roller
2. Bolt
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
to
22
4
3
1
2
Figure 20
3. Flange Nut
4. Hole spacing
Figure 21