Nobu NBL4-12IDU32 User Manual page 13

Introduction for buttons on remote controller
Note:
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
● After putting through the power, the air conditioner will give out a sound.
Operation indictor "
conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon "
on the display of remote controller will blink once and the air conditioner will give
out a "de" sound, which means the signal has been sent to the air conditioner.
1
ON/OFF button
Press this button can turn on or turn off the air conditioner. After turning on the air
conditioner, operation indicator "
The colour is different for different models), and indoor unit will give out a sound.
2
MODE button
Press this button to select your required operation mode.
● When selecting auto mode, air conditioner will operate automatically according
to the sensed temperature. Set temperature can't be adjusted and will not be
displayed as well. Press "FAN" button can adjust fan speed. Press "
button can adjust fan blowing angle.
● After selecting cool mode, air conditioner will operate under cool mode. Cool
indicator " " on indoor unit is ON. Press "▲" or "
rature. Press "FAN" button to adjust fan speed. Press "
fan blowing angle.
● When selecting dry mode, the air conditioner operates at low speed under dry
mode. Dry indicator "
be adjusted. Press "
● When selecting fan mode, the air conditioner will only blow fan, no cooling and
no heating. All indicators are OFF,Operation indicator is ON. Press "FAN" button
to adjust fan speed. Press"
● When selecting heating mode, the air conditioner operates under heat mode.
Heat indicator "
temperature. Press "FAN" button to adjust fan speed. Press "
adjust fan blowing angle. (Cooling only unit won't receive heating mode signal. If
setting heat mode with remote controller, press ON/OFF button can't start up the
unit).
" is ON (red indicator). After that, you can operate the air
AUTO COOL
" on indoor unit is ON. Under dry mode, fan speed can't
" / " " button to adjust fan blowing angle.
" / "
" on indoor unit is ON. Press "▲" or "
" on indoor unit's display is ON (green indicator.
DRY FAN
" button to adjust fan blowing angle.
11
HEAT
" button to adjust set tempe-
" / " " button to adjust
" button to adjust set
" / "
"
" / " "
" button to