AMD FirePro W7000 User Manual page 10

4 Hardware and Software Installation
2. Unplug the computer's power cord, and then disconnect all cables from the back
of the computer.
3. Remove the cover to your computer's case.
Note: If necessary, consult your computer's manual for help in removing the
cover.
4. Unscrew or unfasten and remove any existing graphics card from your
computer, if necessary.
Figure 2–1 Example PCIe Card Slot-locking Mechanism
5. Locate the appropriate slot and, if necessary, remove the metal back-plate cover.
Make sure all internal cables are clear of the slot.
6. Align your AMD FirePro graphics card with the PCIe slot and press it in firmly
until the card is fully seated. You may need to hold open the PCIe card slot-
locking mechanism with your finger when you seat the card.
7. Screw in or fasten the graphics card securely.
AMD FirePro™ W7000 Graphics Accelerator
Caution:
Wait approximately 20 seconds after unplugging the power cord before
disconnecting a peripheral cable or removing a component from the
motherboard to avoid possible damage to the motherboard.
Caution:
Static electricity can seriously damage computer components. Discharge
your body's static electricity by touching the power supply or the metal
surface of the computer chassis before you touch any components inside
your computer's case to avoid damaging them.
Caution:
Make sure the PCIe card slot-locking mechanism is unlocked or open before
trying to remove a graphics card. Failure to do so may damage the card and/
or the motherboard. This locking mechanism may be hidden from view by a
card's fansink.
© 2012 Advanced Micro Devices Inc.