Table of Contents
Advertisement
Reversing the Door
(Black Units Only)
All U-Line units
(except Stainless
Steel models) may be
left- or right-hand
opening. The door
opening is easily
reversed by moving
the hinge hardware
to the opposite side.
The top hinge
hardware will be
used on the bottom
of the other side and
the bottom hinge
hardware will be
used on the top of
the other side (see
Figure 6).
To reverse the door:
1. Remove top
Figure 6
hinge screw pin
from door (Phillips screwdriver) (see Figure 7).
Remove door by tilting forward and lifting off bottom
hinge pin.
2. Remove metal hinge screw plugs (3 each, top and
bottom) from new hinge location. Do not discard (see
Figure 8).
Figure 7
ULIN_0133_A
3. Remove top hinge (3 screws), reinstall hinge screw pin,
and remount on opposite side BOTTOM (see Figure 9).
4. Remove the two door closer inserts from the existing
bottom hinge and install as shown on the new bottom
hinge (see Figure 10).
www.U-LineService.com
2115WC/2115WCOL2 Wine Captain
ULIN_0015_A
Screw Plugs
Figure 8
®
1
2
ULIN_0003_A
Figure 9
5. Remove existing bottom hinge (3 screws) and remount
on opposite side TOP. Remove hinge screw pin.
6. Remove the plastic hole plug from the top of the door
to allow the pivot pin to be inserted in the new
location. Install the plug into the vacated hole on the
opposite side.
7. With bottom of door facing up, remove pivot plate
(2 screws), flip over, and remount on opposite side of
door (see Figure 11). Be sure angled side of plate faces
center.
Figure 11
8. Holding door upright with top of door tilted forward,
place hole of door pivot plate on bottom hinge screw
pin (see Figure 12).
9. Tilt top of door into
position in top hinge and
install top hinge screw pin.
10. Install metal hinge screw
plugs removed in Step 2 in
old hinge holes (3 each,
top and bottom).
8
Door
Closer
Inserts
Figure 10
ULIN_0274_A
Figure 12
03/2008
Advertisement
Table of Contents
