NordicTrack NTL18907.1 User Manual page 8

4. Attach the Latch Housing (34) to the left Upright
(20) with two Screws (7); start both Screws
and then tighten both of them. Note: Make
sure that the large hole in the Latch Housing
is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (34). Then, tighten the knob onto the
pin.
5. With the help of a second person, raise the
Walking Platform (15) to the storage position
and make sure that the latch pin is engaged
(see page 24).
Position the Base Plate (75) on the treadmill as
shown. Attach the Base Plate to the Uprights
(20) with the three Base Plate Bolts (77). Note:
It may be helpful if a second person tips the
treadmill slightly as you tighten the Bolts.
Carefully lower the Walking Platform (15) to the
floor (see page 25).
6. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 27). To protect the floor or car-
pet from damage, place a mat under the treadmill.
4
34
Knob
7
Large Hole
5
77
75
8
20
Spring
Collar
Pin
15
20