Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key
standard screwdriver
sembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART
LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If
a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled.
Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.
Base Plate Bolt (77)–3
1. Make sure that the power cord is unplugged.
With the help of a second person, tip the
Uprights (20) down as shown.
Attach the four Base Pads (81) to the bottom of
the Uprights (20) with the four 1" Tek Screws
(82) in the locations shown.
and your own Phillips screwdriver
, and wire cutters
Star Washer (67)–4
. Use the drawings below to identify the as-
1" Tek Screw (82)–4
Screw (7)–2
Handrail Bolt (72)–4
1
82
81
82
81
6
,
81
82
20
81
82
Advertisement
Table of Contents
