Advertisement
TM-5500/5000 Quick Setup Installation Guide
software versions below HER 502 press OK to save). Repeat this procedure
to select more satellites. Press Exit. Go to Auto-Search. Go to Motor
Setting. Use the left/right arrows and select USALS. At the top of the page,
u
se the left/right arrows on the remote. A pop-up menu will appear. Select
Hotbird 13 degree East and press OK. Go to longitude
is
000.1 West). Then go to latitude (South of UK's latitude is 515 North).
Go to Save and press OK. Wait until the signal quality is more than 50
the progress bar. If the signal quality is below 50%, the setting is incorrect
and the longitude needs to be adjusted by, for example 000.2/000.3/000.4 u
to 9 (For each setting go to save). Do not alter the latitude. By this time, if
you have not achieved this successfully, then the installation on the motor is
incorrect.
For Technomate CIP and DAPCI models only
How to Setup a Normal 36Volt 4Cable Positioner
Press the Menu button on the remote. Use the left/right arrows on the
remote until you see the word "Password". Go to User Option and then go
to Positioner. Make sure that the positioner is ON. Press Exit. Use the left
or right arrows until you see Installation. Go to Setup Limit and press OK.
Press OK again. You will then be asked, "Do you want to delete the satellite
p
osition?" Select "Yes" and press OK. East/West will be highlighted. Go
to East Limit. Press and hold the left/right arrows until yo
R
epeat this process for West Limit. Then press Exit and go to Installation.
Press OK. Use the left/ right arrows to select Satellite
w
ill appear. Use the up/down arrows on the remote to select a satellite.
Press the red button on the remote to save. Repeat this procedure if you
want more satellites, then press Exit.
Go to Auto-Search. Use the left/right arrows. A pop-up list of a satellite will
appear. Use the up/down arrows and select, for example Hotbird 13 degrees
East. Press OK and go down to move the positioner. Press and hold the
left/right arrows until the signal quality is at its highest in the progress bar
you cannot find any satellites, refer to the Transponder List on Page 9, and
select an Active TP for that satellite and move the motor until a high signal is
achieved). Press the red button on the remote to save the position. Use t
up/down arrows to go to the satellite and press OK to tune. When the tun
is finished, press Exit. To find more sa
(London's longitude
List. A pop-up menu
tellites, repeat the above instructions.
% in
p
u see "Error".
(If
he
ing
4
Advertisement
