Advertisement
TM-5500/5000 Quick Setup Installation Guide
DiSEqC and select A. Press OK to save. Repeat this process to select mor
e
satellites, for example Astra 19.2 degrees East. Go to DiSEqC and select B
.
Press OK to save. Press Exit.
Go to Auto-Search. Check the progress bar. If the signal quality is above
5
0%, the task is completed. If not, go to DiSEqC A and change it to B, or go
to DiSEqC B and change it to A. Once this is completed, go to Auto-Search
and press OK on the selected satellite to tune. Repeat this process for all
other selected satellites. If Link has been selected, after selecting all your
satellites go to Auto-Search and press OK. The receiver will then
automatically tune all the selected satellites. When the words "Tuning
Finished" appears, press Exit and select the satellite of your choice to view.
H
ow to Setup a Motorised DiSEqC 1.2 System
Press the Menu button on the remote. Use the left/right arrows on the
remote to select Installation. Press OK. Use the left/right arrows to select
Satellite List. A popup menu will appear. Use the up/down arrows on the
remote to select a satellite. Press the red button on the remote to save (For
software versions below HER 502 press OK to save). Repeat this p
rocedure
to select more satellites. Press Exit. Go to Auto-Search. Go to Motor
Setting. Use the left/right arrows and select DiSEqC 1.2. You will be asked
if
you want to Save. Select Yes. Press OK on the Motor Setting of DiSEqC
1.2. The DiSEqC 1.2 menu will appear. At the top
of the page, you will see
a
satellite's name. Use the left/right arrows to select it.
A popup menu will
then appear. Use the up/down arrows to select a satellite (e.g. Hotbird)
. Go
down to move. Hold and press either the left/right arrows until the signal
quality exceeds 50% in the progress bar. If there is no signal, refer to the
Transponder List (See Page 9) and select an Active TP to find the satellite
faster. When the signal quality reaches its highest level, go to Motor Control
and use the left/right arrows to select Save and save the selected satellite by
pressing OK. Repeat this process for extra satellites.
How to Setup a Motorised DiSEqC USALS System
Press the Menu button on the remote. Use the left/right arrows on the
remote to select Installation. Press OK. Use the left/right arrows to select
Satellite List. A popup menu will appear. Use the up/down arrows on the
remote to select a satellite. Press the red button on the remote to save (For
3
Advertisement
