Maintenance; Preventative Maintenance Schedule; Change The Oil; Check Oil Level - Graco King E70 Instructions Manual

Maintenance

Do not open/remove gear cover. The gear side is not
intended to be serviced. Opening the gear cover may
alter the factory set bearing pre-load and may reduce
the product life.
Preventative Maintenance
Schedule
The operating conditions of your particular system
determine how often maintenance is required. Establish
a preventative maintenance schedule by recording
when and what kind of maintenance is needed, and
then determine a regular schedule for checking your
system.

Change the Oil

NOTE: Change the oil after a break-in period of 200,000
to 300,000 cycles. After the break-in period, change the
oil once per year.
1. Place a minimum 2 quart (1.9 liter) container under
the oil drain port. Remove the oil drain plug (G).
Allow all oil to drain from the driver.
F . 7: Oil Drain Plug
IG
2. Reinstall the oil drain plug (G). Torque to 18-23 ft-lb
(25-30 N•m).
Do not over-torque. The drain plug can become
stripped and damaged.
3A8478A
NOTICE
NOTICE
3. Open the oil fill cap (P) and add Graco Part 16W645
ISO 220 silicone-free synthetic EP gear oil. Check
the oil level in the sight glass (K). (See F
until the oil level is near the halfway point of the
sight glass. The oil capacity is approximately 1.0 -
1.2 quarts (0.9 - 1.1 liters). Do not overfill.
Only use oil with Graco part number 16W645. Any
other oil may not lubricate properly and can cause
damage to the drive train.
4. Reinstall the oil fill cap (P).

Check Oil Level

Check the oil level in sight glass (K). (See F
oil level should be near the halfway point of the sight
glass when the driver is not running. If oil is low, open oil
fill cap (P) and add Graco Part No. 16W645 ISO 220
silicone-free synthetic EP gear oil. See F
The oil capacity is approximately 1.0 - 1.2 quarts (0.9 -
1.1 liters). Do not overfill.
P
F . 8: Sight Glass and Oil Fill Cap
IG

Bearing Pre-Load

See F . 8. The bearing pre-loads (R) are factory set
IG
and are not user adjustable. Do not adjust the bearing
pre-loads.
Maintenance
. 8.) Fill
IG
NOTICE
. 8.) The
IG
. 8.
IG
R
K
11