Table of Contents
Advertisement
Available languages
Available languages
RISK OF FIRE!
GB
THIS APPLIANCE IS INTENDED SOLELY FOR BEVERAGE COOLING.
INSTALLATION
Do not tilt the minibar more than 45 ° from the vertical position during transport. Protect it from mechanical
stress. Deformations, especially in the door area, could negatively affect the performance of the minibar.
•
Place the minibar on a stable and level surface. Use the two adjustable front feet for levelling.
•
Leave enough space around the minibar necessary for proper operation.
•
Do not place minibar in too hot or humid places to prevent damage due to humidity.
•
Do not place the minibar on a carpet or other delicate surfaces, the heat from the compressor could
damage them.
Changing the door opening
To access the lower hinge, you will need to tilt the minibar back. Do not tilt the minibar more than 45 degrees
and never place it on its side.
To change the door opening direction:
1.
Remove the plastic cover of the upper hinge and put it aside.
2.
Unscrew the 3 screws that secure the metal hinge structure, carefully slide the door off and place it on
a soft surface.
3.
Remove the plastic insert on the opposite side of the minibar and door. Then attach the upper door hinge
to this side and fasten it with the screws that you previously unscrewed. Replace the plastic hinge cover.
1
4.
Remove the adjustable foot on the bottom of the minibar and set it aside.
5.
Unscrew the two screws securing the lower door hinge and carefully transfer it to the opposite side of the
door. Set the door on the top and bottom hinges before screwing in the hinge (pay extra attention as the
door will be loose). Then attach the adjustable foot with the screws to the opposite side of the minibar.
20
This appliance contains R600a (the coolant isobutane),
natural gas which is very environmentally friendly
but flammable. When transporting and installing the
equipment it is necessary to make sure that no part of
the cooling circuit is damaged. In the case of damage,
reduce the flame and ventilate the premises where the
appliance is located for a few minutes.
2
3
Advertisement
Table of Contents
