Safety Measures - Maxwell MW-4042 Instruction Manual

СONVECTOR MW-4042
Convector is intended only for additional heating of
rooms. It is not meant for operation as main heat-
ing unit.
DESCRIPTION
Support plates with wheels
1.
(Clamp) handle
2.
Power indicator «POWER»
3.
Temperature control knob «MIN/MAX»
4.
Operation mode switch «I/O/II»
5.
Wall brackets
6.
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal opera-
tion current not exceeding 30 mA. To install RCD
contact a specialist.
WARNING! Do not cover the heater to avoid
overheating.

SAFETY MEASURES

Before using the electrical unit, read this instruction
manual carefully and keep it for future reference.
Use the unit for its intended purpose only, as speci-
fied in this manual. Mishandling of the unit may lead
to its breakage and cause harm to the user or his/
her damage to property.
• Before using the unit for the first time, make sure
that the voltage in your mains corresponds to the
unit operating voltage.
• The power cord is equipped with an «europlug»;
plug it into the socket with a reliable grounding
contact.
•
To avoid fire, do not use adapters for plugging
the unit in.
• To avoid mains overloading, provide that no
other electrical appliances with high power con-
sumption are connected to the same outlet the
unit is connected to.
•
Do not place the heater directly under the plug
socket.
• When mounting the unit on the wall, ensure that
the mains socket is below the level of the unit
and easy to access.
• When mounting the unit on the wall, keep the
following gaps: between floor and unit – not
less than 15 cm, between front and upper pan-
els and objects – not less than 45 cm, between
side panels and objects – not less than 25 cm
(pic. 7).
• To avoid burns avoid contact of open body parts
with hot surfaces.
•
Do not use this heater near bathtubs, showers or
swimming pools.
•
Do not use the unit in rooms with high humidity.
•
Place the unit at a distance of not less than
1.5 meters from open flame and containers filled
with water.
•
Provide that no water gets on the unit body.
•
If any water gets on the unit body, unplug the
unit before touching it and only then wipe water
drops.
•
Do not use the unit outdoors or on wet surfaces.
• Do not use the heater surface for drying wet
clothes, towels etc.
•
Make sure to use wheels when placing the unit
on the floor.
•
When using the support wheels, place the unit
on a flat stable surface. Before using the unit
make sure that the wheels are installed properly.
•
Do not use the unit in the rooms where inflam-
mable substances are kept or used.
•
Do not use the unit, if the room temperature is
over +30°C.
• Do not leave the switched on unit when sleep-
ing and do not place it near a sleeping person.
•
Do not cover the unit during operation.
• Avoid blocking of the openings of the unit with
any objects or room interior elements.
•
Do not insert any foreign objects into the unit
grid to avoid fire, injuries or unit damage.
•
Do not turn the unit over during its operation.
•
Before moving the unit, switch it off, pull the
plug out of the socket and let the unit cool down
completely.
•
For children safety reasons do not leave poly-
ethylene bags, used as packaging, unattended.
Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
•
Do not leave children unattended to avoid them
using the unit as a toy.
•
Close supervision is necessary when the unit is
used near children or disabled persons.
• This unit is not intended for usage by children.
Place the unit out of reach of children during the
operation and cooling down.
• The unit is not intended to be used by peo-
ple with physical, sensory or mental disabilities
(including children) or by persons lacking expe-
rience or knowledge if they are not under super-
vision of a person who is responsible for their
safety or if they are not instructed by this person
on the usage of the unit.
•
Do not leave the operating unit unattended.
•
Unplug the unit if it is not being used and before
cleaning.
•
Do not use inflammable, highly explosive, toxic
and cleaning solvents to remove dirt.
• When unplugging the unit, pull the plug but not
the cord.
7
ENGLISH