Operations - Bissell CLEANVIEW 1819 Series User Manual

Operations: Power On & Settings
1
3
Turn the dial on the foot of the vacuum to the desired
setting. If the dial is difficult to turn, tilt the vacuum back
slightly to take the weight off the foot while turning.
Lowest setting –
Medium setting – For medium pile carpet.
Highest setting – For high pile and most shag carpet.
WARNING
To reduce the risk of injury from moving parts while the vacuum is turned on, always move the
vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry
the vacuum while it is running. Always place vacuum on floor with handle in upright position
when using tools.
NOTE: The rotating floor brush continues to rotate while tools are in use. Never place your
fingers under the vacuum when it is running. Never place powerfoot on furniture or uneven
surfaces. Do not place vacuum close enough to objects to pull them into rotating brush.
NOTE: Certain carpets and low humidity conditions may generate small static discharges.
Static discharges are entirely harmless and are not associated in any way with the main
power supply.
6
www.BISSELL.com
Power
Button
Push the Power
Button on the
handle once to
turn the unit ON
and once again to
turn the unit OFF.
For low pile carpet or bare floors.
To pick up debris, it may be necessary
to move up one setting.
2
Press the recline pedal and pull handle
back towards you.
TIP: For optimal carpet
cleaning performance,
adjust to the lowest
practical setting. If your
vacuum is difficult to
push, adjust to the next
higher setting.
TIP: To operate the cord
rewind, gently pull out
power cord and stop when
yellow band is visible on
the cord. Do not pull power
cord beyond the red line.
To return cord, hold plug
and press automatic cord
rewind button locate on
the lower side of the unit.
Do not allow plug to whip
when rewinding.