Fantech Ezifit Installation Instructions

Thru roof exhaust fan

Ezifit Thru Roof

Exhaust Fan

Ø150mm Spigot

CONTENTS & INSTALLATION INSTRUCTIONS

Contents:

Ezifit Fan

Roof Flashing-Metal Deck or,

Roof Flashing-Tile

Duct Support Straps

Installation Instruction

Mounting Screws

Grommet

also available on request;

Flexible duct 150 dia. x 6m long

Internal ceiling exhaust grille

Inspection:

Ensure the unit has arrived in good condition and that the impeller will spin freely.

This product is designed to be installed on a roof up to 45° pitch.

Part No. INST-ECE150

DUCT150-6M

ALG150

Installation on Metal Deck:

1 off.

2 off.

1 off.

12 off.

1 off.

07/07

Table of Contents

Do you have a question about the Ezifit and is the answer not in the manual?

Page 1 Ezifit Thru Roof Exhaust Fan Ø150mm Spigot CONTENTS & INSTALLATION INSTRUCTIONS Contents: Ezifit Fan 1 off. Roof Flashing-Metal Deck or, 1 off. Roof Flashing-Tile 1 off. Duct Support Straps 2 off. Installation Instruction 1 off. Mounting Screws 12 off. Grommet 1 off.
Page 2 Installation: 1. Installation of this product should be carried out by appropriately qualified persons. 2. Cut a hole in the roof 150mm minimum (with regard to roof pitch angle) diameter. The hole should be positioned adjacent to a rafter or other member to facilitate the use of the duct support straps supplied.
Page 3 WARRANTY: Fantech Pty Ltd warrants products of its manufacture when not misused or neglected to be free of defects in workmanship and/or materials. Our obligation under this warranty is limited to repairing or exchanging F.O.B. factory, any part, assembly or portion found to be defective within one year from the date of commissioning but not to exceed eighteen (18) months from date of shipment from our factory.