Fantech Ezifit Thru Roof ERV150 Installation Instructions

Relief vent 150mm spigot

Ezifit Thru Roof

Relief Vent

Ø150mm Spigot

CONTENTS & INSTALLATION INSTRUCTIONS

Contents:

Ezifit Relief Vent

Roof Flashing-Metal Deck or,

Roof Flashing-Tile

Duct Support Straps

Installation Instruction

Mounting Screws

also available on request;

Flexible duct 150 dia. x 6m long

Internal ceiling exhaust grille

Inspection:

Ensure the unit has arrived in good condition.

This product is designed to be installed on a roof up to 45° pitch.

Part No.: INST-ERV150

DUCT150-6M

ALG150

Installation on

12 off.

Metal

Deck:

08/12

1 off.

2 off

1 off.

Page 1 of 3

Table of Contents

Do you have a question about the Ezifit Thru Roof ERV150 and is the answer not in the manual?

Page 1 Ezifit Thru Roof Relief Vent Ø150mm Spigot CONTENTS & INSTALLATION INSTRUCTIONS Contents: Ezifit Relief Vent 1 off. 1 off. Roof Flashing-Metal Deck or, 1 off. Roof Flashing-Tile Duct Support Straps 2 off Installation Instruction 1 off. Mounting Screws 12 off. also available on request;...
Page 2 Installation on Metal Deck: 1. Installation of this product should be carried out by appropriately qualified persons. 2. Cut a hole in the roof 150mm minimum (with regard to roof pitch angle) diameter. The hole should be positioned adjacent to a rafter or other member to facilitate the use of the duct support straps supplied.
Page 3 Part No.: INST-ERV150 08/12 Page 3 of 3...