Troubleshooting - Asko DBI243IB.W.AU Operating Instructions Manual

Troubleshooting

Type of fault on the display
F10 Overfilling water 1
F11 Water outlet fault
F12 Water inlet fault
F40 Inlet valve leakage
F52 Water level fault
F54 Overfilling water 2
F56 Circ. pump fault
F67 Water inlet fault
Press any button to clear the error message.
Problem
Pressing the main power switch
has no effect.
The buttons do not react when
pressed.
28
Action
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department.
See "Water remains in the dishwasher" in the table "Problem"
below. If the problem persists, call the service department.
Check whether dishwasher inlet hose is connected to a pressure
limiting valve (some pressure limiting valves may restrict the supply
of water to the dishwasher).
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call for
service.
Turn off the water tap and call the service department.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, call the service
department.
Turn off the water tap and call the service department.
Call the service department.
Check whether dishwasher inlet hose is connected to a pressure
limiting valve (some pressure limiting valves may restrict the supply
of water to the dishwasher).
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call for
service.
Possible causes
The door is closed.
You have pressed the buttons
too soon after opening the door.
Child lock (button lock)
activated.
The buttons are dirty.
Action
Open the door. The main power
switch only works when the door
is open.
Wait a moment then try again.
See the chapter Settings.
Clean with a dry or slightly damp
cloth.