7 Unit installation
In this chapter
7.1 Preparing the installation site
7.1.1 Installation site requirements of the outdoor unit
ERLA11~16D + EBVH/X11+16S18+23D
Daikin Altherma 3 R F
4P643602-1B - 2022.05
7.1
Preparing the installation site ................................................................................................................................................
7.1.1
7.1.2
7.1.3
7.1.4
7.1.5
Installation patterns ...............................................................................................................................................
7.2
Opening and closing the units................................................................................................................................................
7.2.1
About opening the units ........................................................................................................................................
7.2.2
To open the outdoor unit ......................................................................................................................................
7.2.3
To close the outdoor unit.......................................................................................................................................
7.2.4
To open the indoor unit .........................................................................................................................................
7.2.5
7.2.6
To close the indoor unit .........................................................................................................................................
7.3
Mounting the outdoor unit ....................................................................................................................................................
7.3.1
7.3.2
7.3.3
7.3.4
To install the outdoor unit .....................................................................................................................................
7.3.5
To provide drainage ...............................................................................................................................................
7.3.6
To install the discharge grille .................................................................................................................................
7.4
Mounting the indoor unit.......................................................................................................................................................
7.4.1
About mounting the indoor unit............................................................................................................................
7.4.2
7.4.3
To install the indoor unit........................................................................................................................................
7.4.4
Choose an installation location with sufficient space to transport the unit in and
out of the site.
Do NOT install the unit in places often used as work place. In case of construction
works (e.g. grinding works) where a lot of dust is created, the unit MUST be
covered.
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
WARNING
DO NOT reuse refrigerant piping that has been used with any other refrigerant.
Replace the refrigerant pipes or clean thoroughly.
INFORMATION
Also read the following requirements:
▪
"2 General safety
▪
"7.1.3 Installation site requirements of the indoor
length and height difference).
4
precautions" [
10].
7
Unit installation
|
4
unit" [
66] (refrigerant piping
Installer reference guide
63
63
65
66
67
68
76
76
76
77
77
79
80
80
80
80
80
81
82
83
84
84
84
84
85
63