Ebyte E70-433NW30S User Manual page 20

Chengdu Ebyte Electronic Technology Co,;Ltd
Example：AT+DFCFG
AT+RSTART Device Restart
17
AT+RSTART
Example：AT+RSTART
AT+ECHO Sets up the AT instruction to turn off the back display
AT+ECHO=Value
18
Example：AT+ECHO=1
Note：This command takes effect after configuration, and will be saved after power off..
AT+VER Reading the version number
19
AT+VER
Example：AT+VER
AT+CLINFO Clearing network information of the module
AT+CLINFO
20
Example：AT+CLINFO
Note: The module cannot communicate after clearing the network. It needs to re-establish the network for communication. (thiscomman allows
the user to clear all information when the number of node devices connected to the coordinator reaches 200.)
AT+TLCFG Setting/Querying the concurrency performance parameter (restart to take effect)
AT+TLCFG=？
AT+TLCFG=value
21
Example: AT+ TLCFG =0
(Note: This parameter is mainly used to configure the concurrency performance of the module. That is, when various nodes concurrently
transmit data, the maximum number of nodes is supported. The higher the performance, the greater the number of concurrent systems, but the
delay in sending data and the average power consumption of the nodes will increase; the lower the performance, the higher the real-time
performance of the data sent by the nodes, but the data may be lost when the environment has large interference or multiple nodes transmit
simultaneously.)
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
Description：Null
Device Restart
Description:
Value:0 or 1
1：Close the echo
0：Open the echo
Description:
Description:
Description:
Gets the concurrency performance parameter
Response：
TLCFG:0
Description:
Value:0~3
0：Low concurrency
1：Medium concurrency
2：High concurrency
3：Highest concurrency
E70-433NW30S user manual
19