Ebyte E70-433NW30S User Manual page 13

433mhz 1w star network smd wireless module

Hide thumbs Also See for E70-433NW30S:

Table of Contents

Chengdu Ebyte Electronic Technology Co,;Ltd

Then enter "AT+WMCFG=0" with line breaks to configure the device as the coordinator mode, as shown in Figure

5-2:

Then enter "AT+RSTART" with line breaks to restart the device. The coordinator configuration is complete. As

shown in Figure 5-3:

8.1.2 Normal node configuration

Open the serial port assistant and select the serial port corresponding to the device. Set the baud rate to 115200, the

data bit to 8 bits, the parity bit to none, the stop bit to 1 bit, and the flow control is disabled, open the serial port.

Enter "+++" without line breaks to enter the AT command mode. When receiving "Enter AT Mode", the AT mode is

Enter "AT+HELP" with line breaks to see all instructions. As shown in Figure 5-4:

Chengdu Ebyte Electronic Technology Co,;Ltd

Figure 5- 1

Figure 5-2

Figure 5-3

successfully entered.

E70-433NW30S user manual

Table of Contents