Chapter 3 Using the stand
To lower the stand
1. Press and hold the Down button on the control panel.
2. Release the Down button to stop lowering the display.
Resetting the stand
If the stand lowers but does not move when you try raising it or if you replace the controller, perform a
factory reset by following the steps below.
To factory reset the stand
1. Connect the stand to a power outlet.
2. Press the Down button and lower the stand to the lowest position.
3. Press the Down button for five seconds. The stand moves up and down 1 cm.
4. Release the Down button.
smarttech.com/kb/171845
16