Table of Contents
Advertisement
Chapter 3 Using the stand
8. After the stand is moved, flip the caster brakes down to lock them and secure the stand in place.
9. Connect the power cable to the outlet and secure any cables that run along the floor.
Raising, lowering, calibrating, and resetting the
stand
Warnings
Ensure the locking bolts are securely tightened before operating the stand.
l
Do not allow children or people who are not able to safely operate the stand to use it.
l
Lock the casters before raising or lowering the stand.
l
Operating the stand can create a hand-crushing or hand-pinching hazard. To prevent injury,
l
keep hands and people away from crush and pinch locations on the stand.
Allow adequate clearance above and below the stand to ensure safe raising and lowering.
l
Use the stand only on a flat surface.
l
Caution
Do not raise and lower the stand for more than two minutes at a time.
Calibrating the stand
After assembling the stand, you must calibrate it before you start to use it.
To calibrate the stand
1. Connect the stand to a power outlet.
2. Press the Down button and lower the stand to the lowest position.
3. Press the Down button for five seconds. The stand moves up and down 1 cm.
4. Release the Down button
Raising and lowering the stand
To raise the stand
1. Press and hold the Up button on the control panel.
2. Release the Up button to stop raising the display.
smarttech.com/kb/171845
15
Advertisement
Table of Contents
