Getting Started - LG U9CV1C Owner's Manual

WARNING
• The remote controller uses button/coin type
batteries (CR2025).
• Swallowing batteries may cause serious
injury or death. Go to hospital emergency
room immediately to seek medical attention.
• Keep the battery out of reach of children.
• If the battery tray is not secured firmly, stop
using the appliance immediately and keep it
away from children.
CAUTION
• Do not arbitrarily modify the battery.
• Do not recharge or disassemble the battery.
• Do not throw the battery into a fire for
disposal or leave it near heat.
• Do not press multiple buttons at the same
time.
• Do not use it in a place with a lot of water or
moisture.
• Do not use it in a place with flames or heat.
• Remove and store the battery in a safe
location if you do not intend to use the
remote controller for a long time.
Note
• If the remote controller is not operating
properly, check the polarity (+, -) of the
battery or replace the battery before
contacting the service center.
• When using the remote controller, point the
remote controller transmitter toward the
receiver on the product.
• The remote controller is not received
properly at a distance of more than 7 m from
the product.
• The remote controller signal reception may
be interrupted when strong lights such as
fluorescent lamps or neon signs are present.
In this case, use the remote controller in
front of the remote signal receiver of the
indoor unit.

Getting Started

Press the Standby On/Off button to start
operation.
Note
• When starting operation for the first time
after installing the product, it will operate in
Wide mode and with step 5 of fan speed.
• If you stop operation and resume it, it
will start cleaning with the mode you last
selected.
• Even if power is lost due to a blackout, the
product will remember the mode(Fan speed,
Mode, Display brightness) you used last.
• When you start driving, the dust
concentration is displayed after sensor
stabilization (about 15 seconds). While
sensor stabilization is in progress, the clean
stabilization screen (
status display.
) appears on the
17
EN