Starting The Pump; Maintenance And Cleaning - FLOWTECH flowpac compact 1F.D Operation And Maintenance Manual

Starting the pump

Given the different provisions applicable to the safety of electric systems in different countries, make sure that
the pump system, as concerns its intended use, is in accordance with current legislation.
Before starting the pump, make sure that:
The voltage and frequency specified on the pump's nameplate coincide with those of the available
•
power supply;
There are no signs of damage to the pump or its power cord;
•
The electric connection is made in a dry place, protected against any risk of flooding;
•
The electric system is complete with a residual current circuit-breaker (I ∆n ≤ 30 mA) and an efficient
•
earthing connection;
Any extension cords must comply with the requirements of the DIN VDE standard 0620.
•
Recommendations
To ensure the proper operation of the pump, it is important to comply with the following recommendations:
The pump must only be used when it is immersed in water.
•
The pump must be placed in a stable position inside a trap or in the lowest part of the place where it is in-
•
stalled.
Periodically, it is advisable to make sure that no dirt (leaves, sand, etc.) has accumulated in the collection
•
trap.

Maintenance and Cleaning

It is absolutely essential to prevent any risk of the pump freezing. In the event of freezing temperatures, remove
the pump from the liquid, empty it and keep it in a place where it cannot freeze. The pump must be disconnected
from the mains power supply before any cleaning operation is performed. The pump is maintenance free.
Guarantee
Any material or manufacturing defects will be corrected during the guarantee period established by current law
in the country where the product is purchased. It is up to the manufacturer to decide whether to repair or replace
any faulty parts.
The manufacturer's guarantee covers all substantial defects attributable to manufacturing or material defects,
providing the product has been used correctly and in compliance with the instructions.
The guarantee becomes null and void in the event of the following:
unauthorized attempts to repair the appliance;
•
unauthorized technical changes to the appliance;
•
use of non-original spare parts; manhandling;
•
inappropriate use, e.g. for industrial purposes.
•
The guarantee does not cover:
parts liable to rapid wear and tear.
•
For any action under guarantee, contact an authorized customer support service, presenting your receipt for
the purchase of the product.
flowpac compact
1F.D Pump Manual
7