Table of Contents
Advertisement
EPRA14~18D + ETSH/X(B)16P30+50E
Daikin Altherma 3 H HT ECH₂O
4P679467-1B – 2022.09
This needs the following components in case of WLAN module:
a
a
WLAN cartridge
WLAN module
b
Router
c
Smartphone + app
Configuration
To configure the ONECTA app, follow the in-app instructions. While doing this, the
following actions and information are needed on the user interface:
Mode: Turn AP mode ON (= WLAN cartridge/module active as access point) or OFF.
#
Code
[D.1]
N/A
Reboot: Reboot the WLAN cartridge/module.
#
Code
[D.2]
N/A
WPS: Connect the WLAN cartridge/module to the router.
#
Code
[D.3]
N/A
b
c
The WLAN cartridge needs to be inserted in the
user interface. See the installation manual of the
WLAN cartridge.
The WLAN module needs to be installed by the
installer on the indoor unit (on the inside of the
front panel). See:
▪
Installation manual of the WLAN module
▪
Addendum book for optional equipment
Field supply.
The ONECTA app needs to be installed on the
user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Description
Enable AP mode:
▪
No
▪
Yes
Description
Reboot the gateway:
▪
Back
▪
OK
Description
WPS:
▪
No
▪
Yes
10
Configuration
|
Installer reference guide
233
Advertisement
Table of Contents
