Table of Contents
Advertisement
Quick Links
NATHAN AIRCHIME
INSTALLATION MANUAL
Nathan P3, P5, K3LA, K5LA 540 Kit
WARNING: To ensure the longevity of
your system, reading and following these
instructions are recommended. Make sure
to change filters and to drain the moisture
from your tank on a regular basis.
Advertisement
Table of Contents
Related Manuals for HornBlasters Nathan P3
Summary of Contents for HornBlasters Nathan P3
- Page 1 NATHAN AIRCHIME INSTALLATION MANUAL Nathan P3, P5, K3LA, K5LA 540 Kit WARNING: To ensure the longevity of your system, reading and following these instructions are recommended. Make sure to change filters and to drain the moisture from your tank on a regular basis.
-
Page 2: Before Getting Started
• 1 x Pressure Switch w/ Relay • 17’ 18 Gauge Wire • 1 x 10-12 Gauge Scotch Lock • 1 x HornBlasters Gauge • 1 x Toggle Switch • 1 x 18-22 Gauge Scotch Lock • 1 x Teflon Tape •... - Page 3 • 7/8” Wrench (1/2” Banjo) • 10mm Wrench or Socket (Air Source Mounting) I. INSTALLING YOUR HORNBLASTERS TRAIN HORNS Locate an area for your horns that is dry and free from debris. The horns can be mounted in any direction and still be heard from all around.
- Page 4 6. Now run the air line from your horn manifold to the air tank and cut the length required. Make sure the cut end is at and the cut is completely perpendicular to the tubing length. 7. Finally install the air line carefully between the horns and the air valve making sure not to damge the PTC fittings. www.hornblasters.com support@hornblasters.com...
- Page 5 AIR GAUGE IN TANK: 1. Install the Hornblasters Air Gauge into available 1/2” port on the air tank using Teflon tape or pipe sealant on the threading of the 1/2” to 1/4” NPT F bushing. Make sure to mount the air pressure gauge on the side or the top of the tank so that condensation will not be able to drain in to the gauge.
-
Page 6: Maintenance & Tips
CAN’T FIGURE IT OUT? No problem! Give us a call at 813-783-8058, or email at support@hornblasters.com and we’ll be more than happy to help you fix your system. Also feel free to visit our online horn community, www.trainhornforums.com, for more information. - Page 7 Trainhornforums.com is the largest train horn community online and provides a place to share photos of your ride, post videos, catch up with other train horn and HornBlasters fans, meet other train horn enthusiasts, or even find help with a complicated question.
- Page 8 If your horn system is negatively activated, then you will need to wire one of the leads from the value to a direct 12v power source. Then wire the other lead to the megatively charged horn wire. www.hornblasters.com support@hornblasters.com...