Before Getting Started; Kit Contents; Important Safety Instructions - HornBlasters Nathan P3 Installation Manual

Table of Contents

Advertisement

6511 54th St
Tampa, FL 33610
NATHAN AIRCHIME INSTALLATION GUIDE

BEFORE GETTING STARTED

Read over the entire instruction guide before you begin your installation.

KIT CONTENTS:

• Nathan AirChime P3, P5, K3LA, K5LA
• Viair 325/400/444/480 Air Compressor
• 1/2" SMC Electric Solenoid Valve
• 17' 1/2" Airline
• 4 x 1/2" PTC to 1/2" NPT
• 17' 10 Gauge Wire
• 17' 18 Gauge Wire
• 1 x Toggle Switch
• 1 x Inline Fuse Holder
IMPORTANT: This complete train horn kit uses 12 volt DC components. Only install this kit
with a 12 volt DC power source.

IMPORTANT SAFETY INSTRUCTIONS

CAUTION: To prevent the risk of electrical shock or electrocution:
• Do not disassemble any electrical components of this horn kit (air compressor, air valve, pressure switch).
• Do not attempt repairs or modifications of any component. Please refer to qualified service agencies for all service
and repairs.
• Do not operate any component where it can fall or be submerged into water or any kind of liquid.
• Do not reach for any component that has fallen or been submerged into water or any kind of liquid.
• Use the included components with 12 volt DC systems only.
• Do not leave the air system unattended during use.
WARNING: To prevent injury:
• Never allow children to operate the compressor or air horn. Use close supervision when operating this equipment
near children.
• The air compressor will become very HOT during and immediately after operation. Do not touch any part of the
compressor with your bare hands during or immediately after use.
• Do not use this product near open flames, explosive materials or where aerosol products are being used.
• Do not operate this product where oxygen is being administered.
• Do not pump anything other than atmospheric air.
• Never use this product while sleepy or drowsy.
• Do not use any tools or attachments with the supplied air source unit without first determining maximum air
pressure for that tool or attachment.
• Never point any air nozzle or air sprayer toward another person or any part of your body.
• The included compressor is equipped with an automatic reset thermal protector and can automatically restart after
the thermal protector resets. Always cut off power source when thermal protector becomes activated.
• Use only in well ventilated areas.
• Do not sound the air horn(s) in close proximity to another person's or your own ear(s).
• Do not fill the included air tank above 150 PSI. Doing so may result in death or serious injury.
www.hornblasters.com
• 5 x 18-22 Gauge Butt Connector
• 3 x 10-12 Gauge Butt Connector
• 2 x 18-22 Gauge Ring Terminal
• 1 x 10-22 Gauge Ring Terminal
• 1 x 10-22 Gauge Male Quick Disconnect
• 1 x 18-22 Gauge Male Quick Disconnect
• 1 x 10-12 Gauge Scotch Lock
• 1 x 18-22 Gauge Scotch Lock
• 1 x 35 Amp Fuse
+1 (813) 783-8058
Fax: +1 (813) 783-2407
• 1 x 1/4" 175 PSI Safety Valve
• 5 x 1/2" NPT to 1/4" Reducer
• 1 x 1/2" Plug
• 1 x 3/4" Plug
• 1 x 1/4" Drain Cock
• 1 x Pressure Switch w/ Relay
• 1 x HornBlasters Gauge
• 1 x Teflon Tape
• 1 x Horn-Air 5 Gallon Tank
support@hornblasters.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nathan p5Nathan k3laNathan k5la 540

Table of Contents