Arctic Cat 700 DIESEL Operator's Manual page 60

8. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
9. Turn the engine off and wait approxi-
mately three minutes. Recheck oil level.
10. Inspect the area around the drain plug
and oil filter for leaks.
Transmission Lubricant
(Inspecting/Changing)
Check and change the transmission lubri-
cant according to the Maintenance Sched-
ule. When adding or changing the lubricant,
use approved SAE 80W-90 hypoid oil and
use the following procedure.
1. Place the ATV on level ground.
2. Remove the transmission fill plug.
Make sure not to allow contaminants
to enter the opening.
3. Remove the transmission drain plug
from the bottom of the transmission
and drain the lubricant into a drain pan.
4. Install the drain plug and tighten
securely. Pour recommended lubricant
into the filler hole. Install the filler plug.
5. Remove the transmission lubricant
level stick and wipe it with a clean
cloth; then check the lubricant level
with the level stick.
58
Front Differential and Rear
Drive Gear Lubricant
(Inspecting/Changing)
Check and change the gear lubricant in
each according to the Maintenance Sched-
ule. When adding or changing the lubri-
cant, use approved SAE 80W-90 hypoid
oil and use the following procedure.

NOTE: To check each, remove
each filler plug. The oil should be 1
in. below the threads of each plug.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by remov-
ing in turn the drain plug from each.
DE026A
DE016A
DE002A
CF107B
CF106C