Table of Contents
Advertisement
Getting started
Battery installation
Install the battery as shown below.
1
Plug the battery connector
securely into the socket inside the
battery compartment, matching
the color-coded label.
3
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below).
•
For best performance, keep the handset in the telephone base or charger when
not in use.
•
The battery is fully charged after 16 hours of continuous charging.
•
If the handset will not be used for a long time, disconnect and remove the
battery to prevent any possible leakage.
Battery indicators
The screen is blank.
The screen shows
Place handset in
charger and
flashes.
The screen shows Low
battery and
flashes.
The screen shows
HANDSET.
Battery status
Battery has no charge and the
handset cannot be used.
Battery has very little charge
and the handset cannot be
used.
Battery has enough charge to
be used for a short time.
Battery is charged.
2
Place the battery with the label
THIS SIDE UP and the wires
inside the battery compartment.
Charge the handset by placing it
in the telephone base.
CHARGE light remains
on when charging.
Action
Charge without interruption (at
least 30 minutes).
Charge without interruption (at
least 30 minutes).
Charge without interruption (at
least 30 minutes).
To keep the battery charged,
place it in the telephone base
when not in use.
Advertisement
Table of Contents
