Installing The 3.5-Inch Hard-Disk Drive Assembly (Bay-2) - Dell Precision 3660 Tower Service Manual

Steps
1. Place the hard-disk drive into the hard-disk drive bracket and align the tabs on the bracket with the slots on the hard-disk
drive.
2. Snap the hard-disk drive into the hard-disk drive bracket.
Next steps
1. Install the 3.5-inch hard-disk drive
2. Install the side cover.
3. Follow the procedure in

Installing the 3.5-inch hard-disk drive assembly (Bay-2)

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-disk drive assembly and provides a visual representation of the
installation procedure.
Steps
1. Slide and insert the 3.5-inch hard-disk drive assembly into the hard-disk drive slot.
2. Route the power cable and the data cable through the routing guides on the hard-disk drive assembly and connect the
cables to the hard-disk drive.
20 Removing and installing components
assembly.
after working inside your computer.