Canon 3794C002 Instruction Manual page 55

Icon/Display
4
Recording operation
STBY, REC
Ü
S&F STBY,
S&F REC
Ü
PRE STBY,
PRE Ü REC
`
00.00P, 00.00i
U
00:00:00.00 / 00:00:00:00
R, P, F, E
Power supply level indicator
è  é 
 
ê ë
(in red)
000 min
DC IN 00.0V
è  é 
 000%,
ê ë
00.0V
Right side of the screen
Icon/Display
( only),
,
60(24)fps, 60(30)fps
( only)
0000x0000
00 bit,
YCC422 00 bit
7
(in red)
T (in red)
^ (in yellow)
J, K (in yellow)
Double slot recording (A 47).
Clip recording: record standby, recording.
Slow & fast motion recording (A 115): record standby, recording.
Pre-recording (A 118): record standby, recording.
Recording command (A 145, 146).
Frame rate (A 63).
When slow & fast motion recording is activated, the shooting frame rate is also
displayed (000/00.00P).
Genlock (A 98).
• Displayed only when an optional EU-V1 Expansion Unit 1 or EU-V2 Expansion
Unit 2 is attached to the camera.
Time code (A 94).
Time code status (A 95).
Remaining battery charge of a BP-A60 (supplied) or BP-A30 (optional) Battery Pack
and estimated remaining usage time (in minutes).
• When is displayed, replace the battery pack with a fully charged one.
• Depending on the conditions of use, the actual battery charge level may not be
indicated accurately or may not match the levels shown on the [B System
Setup] status screen or the indicators on the battery pack.
Power supply voltage when using an AC adapter.
• When the voltage falls below the selected low-power warning level (A 194),
the voltage will be displayed in red.
Remaining battery charge of a commercially available V-mount battery.
• Available only when the optional EU-V2 Expansion Unit 2 is attached to the
camera.
• Depending on the battery used, the battery charge level cannot be indicated as
a percentage. In that case, the voltage will be displayed instead.
• When the power level falls below the selected low-power warning level
(A 194), the percentage or voltage will be displayed in red.
Sensor mode (A 62).
Output Terminals Status (A 121).
Resolution (A 62).
Color depth, color sampling (A 62).
Photo recorded on the SD card (A 52).
No SD card or cannot record photos on the SD card.
MON. terminal disabled / HDMI OUT terminal active (A 145).
Output onscreen displays (A 147).
Magnification (A 83).
Peaking (A 83).
Description
Description
Recording Video and Photos
Custom Display
2: [Recording Mode]
2: [Rec Command]
2: [Frame Rate]
2: [Genlock]
2: [Time Code]
2: [Remaining Battery]
Custom Display
2: [Sensor Mode]
2: [Output Terminals
Status]
2: [Resolution/
Color Sampling]
2: [Photo]
2: [Output Terminals
Status]
2: [OSD Output]
1: [Magnification]
1: [Peaking]
55