Safety Instruction; General Safety; Environment Requirements - EcoFlow PowerStream User Manual

Safety Instruction

General safety

1. Please carefully read the documents before installing, operating or maintaining the equipment.
The documents are subject to change due to product updates or other reasons.
2. Do not put heavy objects on the equipment.
3. Ensure that all cables and connectors are intact and dry before connecting to prevent electric
shocks.
4. Use insulation tools or wear personal protective equipment when you install or operate the
equipment.
5. Do not install or operate the equipment in extreme weather events such as lightning, snow,
heavy rain, strong wind and so on.
6. Do not damage, smear or rip off any warning labels on the equipment.
7. Do not hit, pull, drag, squeeze or step on the equipment, or throw it into the fire, as there is risk
of explosion.
8. After installing, please clean the remains of the installation, such as boxes, clipped cable ties,
ripped insulation materials, etc.
9. Do not modify or repair the equipment, please contact our customer service or qualified
personnel if necessary.
10. Use tools and the equipment correctly to prevent personal injuries and product damage.
11. Understand the components and function of the grid-tied PV power system. Make sure that
all electrical connections, and voltage and frequency at the connection point meet the local
microinverter grid-tie requirements.
Make sure the screws are tightened to the specified torque during installation (M5*12: 30
12.
Kgf*cm; ST5*12: 45 Kgf*cm; M6*20: 90 Kgf*cm).
13. Make sure that the ground wire is tightly connected. The cross-section of ground wire should
be ≥ 4 mm².
14. It is strongly recommended to install an overcurrent circuit breaker between the equipment
and the grid.
15. The equipment may get more than 70 °C (158 °F) while in use. Do not touch its enclosure
before it cools down. Also, always keep the equipment out of reach of children and pets.
16. The installation location should be convenient for you to pull out the connectors.
17. Before you pull out the AC (or battery) connector from the microinverter, disconnect the cable
from the AC socket (or battery's) end.
18. Make sure the portable power station is off during the whole connection process.

Environment requirements

1. Make sure the equipment is intalled, operated or stored in a well ventilated place.
2. Do not install or operate the equipment near flammable, explosive, corrosive, caustic or moist
sources.
3. Do not expose the equipment to strong electromagnetic fields to avoid radio interference.
1