Doro Tel 2i - Telephone Manual

Table of Contents

Contents

1 Introduction
2 Connection
3 Mute button
4 Redial button
5 Volume control
6 Memory
7 Ringer
8 Wall mounting
9 Troubleshooting
10 Documents / Resources
- 10.1 Download manual

Introduction

This device is intended for the analogue telephone network lines in AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT, LU, MT, NL, NO, PL, PT, RO, SI, SK, SE.

Connection

Connect the cord to the network socket.

Mute button

The microphone can be turned off/on, press .

Redial button

Press the redial button .

Volume control

The volume may be adjusted using .

Memory

The telephone will store 3 one-touch(M1-M3) and 10 two-touch memories (up to 21 digits).

Storing One-touch Memories

Lift the handset, press (ignore the dial tone).
Press desired location M1-M3.
Enter the number. Press , replace the handset.

Dialing using One-touch Memories
Lift the handset and press desired location M1-M3.

Storing Two-touch Memories

Lift the handset, press (ignore the dial tone).
Press .
Press desired location .
Enter the number. Press, replace the handset.

Dialing using Two-touch Memories

Lift the handset, press .
Press desired location .

Press if you want a pause in the telephone number.

Ringer

Lift handset, press (ignore dial tone).
Select ring signal by pressing in accordance with the table below.
Press and replace the receiver.

Melody type	Key/level
Melody A	1=Low, 2=Normal, 3=High
Melody B	4=Low, 5=Normal, 6=High
Melody C	7=Low, 8=Normal, 9=High
Off*	0

* If the key 0 is selected, the ring signal will be turned off until the next time the receiver is lifted. After that, the ring signal will revert to the previous setting.

Wall mounting

Secure two screws, vertically positioned 83 mm apart.
The screws should locate into the two keyholes on the back of the telephone.
Remove the hanging peg (located by the hook switch) by pushing it upwards.
Rotate the hanging peg 180 degrees, and then replace it.

Troubleshooting

Check that the telephone cord is undamaged and properly plugged in. Disconnect any additional equipment that may be connected. If the problem is resolved the fault is with the other equipment. Test the equipment on a known working line, if the product works then the fault is with the line. If you are still experiencing difficulties, contact the place of purchase.