Silvercrest SEAD 1800 A1 Operating Instructions Manual page 11

NOTICE
►
Preparing food/preserve jars
Preferably use preserving jars with a rubber seal and a lever clamp. The
preserving jars must be free of damage.
1) The preserving jars must be free of germs and bacteria, otherwise the
2) Use a funnel when filling the preserving jars, if available. The edges of the
3) Seal the jars as quickly as possible after filling:
The preserving jars are now ready for preserving.
Using the appliance
Switching the appliance on and off
1) Using the control dial "Temperature" 9, set the desired temperature. You
2) Using the control dial "Minutes" 3 set the desired cooking time in minutes.
NOTICE
►
3) Press the START/STOP 9 heating button. The heating begins. The heating
│ GB │ IE
■ 8
IB_411310_SEAD1800A1_LB8.indb 8 IB_411310_SEAD1800A1_LB8.indb 8
On the first use the generation of a slight smell may occur, this is due to
residues from the production. It is completely harmless and disperses after
a short time. Provide for sufficient ventilation, for example, open a window.
preserve could spoil prematurely. Preferably, boil the preserving jars for
5 –7 minutes before adding the food.
preserving jars must be clean when the jars are sealed.
–
Place the rubber seal on the upper rim of the preserving jar and place
the glass lid on the preserving jar. The rubber seal is between them.
–
Fasten the glass lid with the clamps: Fit the locking clamps opposite each
other.
can set the temperature in 1 °C steps. A signal tone sounds for every 5 °C.
The set temperature appears in the display indicator "Set Temperature" 7.
You can set the time in 1 minute steps. A signal tone sounds for every
5 minutes. The set time appears in the display indicator "Minutes" 5.
The background lighting of the display goes out after about 5 minutes
after the last activation of one of the dials if you do not start the heating
process. The settings on the display remain visible. Turning one of the
dials will reactivate the background lighting in the display.
progress in indicated through the continous beam "
heating temperature is shown in the display indicator " Current Temperature" 6.
Once the heating up is complete, signal tones sound, "
display and the time set in the display indicator "Minutes" 5 begins to
count down.
". The momentary
" appears in the
SEAD 1800 A1
23.01.2023 16:19:55 23.01.2023 16:19:55