Table of Contents
Advertisement
2.10.4
Screen brightness
From this menu you can change the brightness of the display.
– Press the selector
– Turn the
selector to adjust the brightness of the dis-
play when it is in active mode (from 20% to 100%).
– Press the selector
2.10.5
Standby settings
Standby settings
Brightness in standby
Standby timing
Screen saver selection
– "Brightness in standby": allows for setting the dis-
play's level of brightness when the device is in stand-by
mode (from 0% to 30%).
– "Standby timing": allows to set the time interval (from
1 to 10 minutes) from the last operation made on the
device, after which the screen enters stand-by mode
and its brightness is reduced to the value set for the
stand-by mode.
– "Screen saver selection": allows to select the type of
screen to be displayed in stand-by mode.
Standby settings
Brightness in standby
Standby timing
Screen saver selection
– "OFF": displays the selected home page.
– "Room T": displays the current room temperature.
to enter the edit mode.
to confirm.
70%
1 min
Room T
Fig. 65
OFF
70%
Room T
1 min
Fig. 66
2.11 Advanced settings
2.11.1
CH settings
Advanced settings
CH settings
Cooling settings
AUTO function
Buffer
Heat Pump
System measurement unit
– "CH setpoint temperature": in the menu you can set
the water temperature set-point in heating mode for
each hydraulic zone present in the system. The menu
can be used to:
– adjust the temperature set-point if the automatic
temperature control function ("AUTO function") is
disabled.
– apply a correction to the temperature set-point us-
ing a slider, if the automatic temperature control
function ("AUTO function") is active and the water
temperature does not match the desired tempera-
ture.
T set Z1
-
Push Ok to confirm
User Menu
>
>
ON
>
>
International
system
Fig. 67
0°C
+
Fig. 68
47 / EN
Advertisement
Chapters
Table of Contents
