Table of Contents
Advertisement
4.1.1 Media Sensor Calibration
Please follow the steps below to calibrate the media sensor.
1. Turn off the printer power switch.
2. Hold on the FEED button (
3. Release the power switch (
Note: In this moment, you should still hold on the FEED button.
4. The printer will beep sound twice later, then release the FEED button (
when the indicator becomes
5. Printer will calibrate the gap/black mark sensor sensitivity.
Note: You also can do this function by open/close the media cover when turn
on the printer.
The LEDs will be changed as following figures:
Beep sound twice
Turn on the printer
4.1.2 Self-test and Dump Mode
Please follow the steps below.
1. Turn off the printer power switch.
2. Hold on the FEED button (
3. Release the power switch (
Note: In this moment, you should still hold on the FEED button.
4. The printer will beep sound twice later, then release the FEED button (
when the indicator becomes
5. Printer will calibrate the sensor and print out the internal settings, then enter
the dump mode.
Note: Turn off/on the power or press FEED button to resume printer from
dump mode to normal printing mode. Please refer to
4.4
for more details of self-test and dump mode.
) then turn on the power switch (
) when
LED color turn on amber.
and blinking.
(5 blinks)
(5 blinks)
) then turn on the power switch (
) when
LED color turn on amber.
and blinking.
- 30 -
).
)
(5 blinks)
).
)
sections 4.3
and
Advertisement
Table of Contents
